- id: alsa name: ALSA speaker description: Uses the configured output alongside TTS and horn with independent volume controls. setup: | apt-get update && apt-get install -y ffmpeg alsa-utils run: | normalize=true normalize_filter='dynaudnorm=f=75:g=15:m=10:p=0.9,alimiter=limit=0.85:level=disabled' filters=() if [ "$normalize" = true ]; then filters=(-af "$normalize_filter"); fi ffmpeg -nostdin -hide_banner -loglevel warning -fflags nobuffer -flags low_delay \ -analyzeduration 200k -probesize 32k -rtsp_transport tcp -i "$ROVER_AUDIO_PLAYBACK_URL" \ -vn "${filters[@]}" -ac 1 -ar 16000 -f s16le pipe:1 | aplay -q -D "$ROVER_AUDIO_OUTPUT_DEVICE" -t raw -f S16_LE -r 16000 -c 1 - id: aiy name: Google AIY Voice HAT speaker description: HAT playback with low-latency decoding and 16 kHz mono output through the configured audio route. Reboot once after initial setup. setup: | set -euo pipefail boot=/boot/firmware/config.txt [[ -f "$boot" ]] || boot=/boot/config.txt [[ -f "$boot" ]] || { echo 'AIY setup needs a Raspberry Pi boot config.txt' >&2; exit 1; } changed=0 for setting in dtparam=i2s=on dtoverlay=googlevoicehat-soundcard; do if ! grep -Fxq "$setting" "$boot"; then # Leave any model-specific section before adding shared HAT settings. if [[ "$changed" == 0 ]]; then printf '\n[all]\n' >> "$boot"; fi printf '%s\n' "$setting" >> "$boot" changed=1 fi done if [[ "$changed" == 1 ]]; then echo 'AIY hardware enabled. Reboot the host once before using this sound card.' fi apt-get update && apt-get install -y ffmpeg alsa-utils run: | normalize=true normalize_filter='dynaudnorm=f=75:g=15:m=10:p=0.9,alimiter=limit=0.85:level=disabled' filters=() if [ "$normalize" = true ]; then filters=(-af "$normalize_filter"); fi ffmpeg -nostdin -hide_banner -loglevel warning -fflags nobuffer -flags low_delay \ -analyzeduration 200k -probesize 32k -rtsp_transport tcp -i "$ROVER_AUDIO_PLAYBACK_URL" \ -vn "${filters[@]}" -ac 1 -ar 16000 -f s16le pipe:1 | aplay -q -D "$ROVER_AUDIO_OUTPUT_DEVICE" -t raw -f S16_LE -r 16000 -c 1