- id: alsa name: ALSA microphone description: Uses the configured audio input device through roverd's ALSA conversion route. setup: | if ! command -v ffmpeg >/dev/null || ! command -v arecord >/dev/null; then apt-get update && apt-get install -y ffmpeg alsa-utils fi run: | exec ffmpeg -nostdin -f alsa -ar "$ROVER_AUDIO_SAMPLE_RATE" -ac "$ROVER_AUDIO_CHANNELS" -i "$ROVER_AUDIO_INPUT_DEVICE" -c:a libopus -b:a "$ROVER_AUDIO_BITRATE" -f rtsp -rtsp_transport tcp "$ROVER_AUDIO_PUBLISH_URL" - id: aiy name: Google AIY Voice HAT microphone description: Same configurable ALSA route; setup enables the HAT overlay. Reboot once after first enabling its hardware. setup: | set -euo pipefail # Capture/playback setup may run concurrently; serialize edits to boot config. exec 9>/var/lock/roverd-aiy.lock flock 9 boot=/boot/firmware/config.txt [[ -f "$boot" ]] || boot=/boot/config.txt [[ -f "$boot" ]] || { echo 'AIY setup needs a Raspberry Pi boot config.txt' >&2; exit 1; } changed=0 for setting in dtparam=i2s=on dtoverlay=googlevoicehat-soundcard; do if ! grep -Fxq "$setting" "$boot"; then # Leave any model-specific section before adding shared HAT settings. if [[ "$changed" == 0 ]]; then printf '\n[all]\n' >> "$boot"; fi printf '%s\n' "$setting" >> "$boot" changed=1 fi done if [[ "$changed" == 1 ]]; then echo 'AIY hardware enabled. Reboot the host once before using this sound card.' fi if ! command -v ffmpeg >/dev/null || ! command -v aplay >/dev/null; then apt-get update && apt-get install -y ffmpeg alsa-utils fi run: | exec ffmpeg -nostdin -f alsa -ar "$ROVER_AUDIO_SAMPLE_RATE" -ac "$ROVER_AUDIO_CHANNELS" -i "$ROVER_AUDIO_INPUT_DEVICE" -c:a libopus -b:a "$ROVER_AUDIO_BITRATE" -f rtsp -rtsp_transport tcp "$ROVER_AUDIO_PUBLISH_URL"