- id: alsa name: ALSA microphone (generic) description: Uses the configured audio input device through roverd's ALSA conversion route. setup: | if ! command -v ffmpeg >/dev/null || ! command -v arecord >/dev/null; then apt-get update && apt-get install -y ffmpeg alsa-utils fi run: | sample_rate=48000 channels=2 bitrate=510000 arecord -D "$ROVER_AUDIO_INPUT_DEVICE" -f S32_LE -c "$channels" -r "$sample_rate" -B 16384 -F 1024 -q -t raw | ffmpeg -nostdin -hide_banner -loglevel warning -fflags nobuffer \ -rtbufsize 0 -thread_queue_size 4096 -f s32le -ar "$sample_rate" -ac "$channels" -i pipe:0 \ -af "volume=20dB" -c:a libopus -b:a "$bitrate" -ar:a "$sample_rate" -ac:a "$channels" \ -application audio -frame_duration 20 -compression_level 0 \ -flush_packets 1 -muxdelay 0 -muxpreload 0 -f rtsp -rtsp_transport tcp "$ROVER_AUDIO_PUBLISH_URL" - id: aiy name: Google AIY Voice HAT microphone (raspberry pi) description: HAT capture with S32_LE input, 20 dB microphone boost, and low-latency Opus settings. Reboot once after first enabling its hardware. setup: | set -euo pipefail boot=/boot/firmware/config.txt [[ -f "$boot" ]] || boot=/boot/config.txt [[ -f "$boot" ]] || { echo 'AIY setup needs a Raspberry Pi boot config.txt' >&2; exit 1; } changed=0 for setting in dtparam=i2s=on dtoverlay=googlevoicehat-soundcard; do if ! grep -Fxq "$setting" "$boot"; then # Leave any model-specific section before adding shared HAT settings. if [[ "$changed" == 0 ]]; then printf '\n[all]\n' >> "$boot"; fi printf '%s\n' "$setting" >> "$boot" changed=1 fi done if [[ "$changed" == 1 ]]; then echo 'AIY hardware enabled. Reboot the host once before using this sound card.' fi if ! command -v ffmpeg >/dev/null || ! command -v arecord >/dev/null; then apt-get update && apt-get install -y ffmpeg alsa-utils fi run: | sample_rate=48000 channels=2 bitrate=510000 arecord -D "$ROVER_AUDIO_INPUT_DEVICE" -f S32_LE -c "$channels" -r "$sample_rate" -B 16384 -F 1024 -q -t raw | ffmpeg -nostdin -hide_banner -loglevel warning -fflags nobuffer \ -rtbufsize 0 -thread_queue_size 4096 -f s32le -ar "$sample_rate" -ac "$channels" -i pipe:0 \ -af "volume=20dB" -c:a libopus -b:a "$bitrate" -ar:a "$sample_rate" -ac:a "$channels" \ -application audio -frame_duration 20 -compression_level 0 \ -flush_packets 1 -muxdelay 0 -muxpreload 0 -f rtsp -rtsp_transport tcp "$ROVER_AUDIO_PUBLISH_URL"